Additional examples are adjusted to the entries in an automated way - we cannot guarantee that they are correct.
The power head is usually supported by punched angle iron.
You can use up to 10 pieces of angle iron to reinforce your rig.
Why do you want to) scream, and take the angle irons in hand.
A 3-speed transmission was fitted, and the car used an angle iron frame.
It was reinforced with a heavy angle iron bolted on top.
The launcher is a simple affair, easy to make with angle iron.
But I warn you that they have to be strengthened from below with angle irons, a couple of days' job in itself.
James looked into crannies on the bulkhead formed by the angle iron.
"We broke apart two beds and took the angle irons," M. says.
Both the bow and stern were also strengthened by heavy frames of double angle iron.
The gate leaves were frames of angle iron wrapped with barbed wire.
Towers were built of numbered angle iron sections with concrete footings.
A thick black-furred arm as solid as an angle iron.
Looks to be made of angle iron."
It was a piece of angle iron with a coaxial cable taped to it.
She knew how to remove the handle, and once removed, it was nothing less than a wieldy angle iron.
Parallel tracks of angle iron were embedded in the flat floor of the tunnel all the way from one end to the other.
The wheels of the makeshift sled fit perfectly into the angle iron tracks that had been set in the tunnel floor.
I've had worse bumps in my life," she said as she struck the angle iron to call Luke.
Only the carefully screwed, black angle iron at its corners offered contrast to its steel-gray color.
Some models have special brackets for this, while other units include metal mounting straps or perforated angle iron.
The bridge had been built in 1844, well before the Dee accident, and patched with the angle iron in 1853.
Most Franklins were wood-framed, although the very first model in 1902 was constructed from an angle iron frame.
A rail-guided system consists of angle iron bolted to the floor down the length of each row.
I made a simple drilling jig from a piece of 25x25x3mm angle iron which covered all the correct distances and spaces.