stator

Recently a Stator was brought to the station via the sea.

In between the rotor and stator is the air gap.

Each end of the stator contains a bearing for the shaft.

For electric motors, the field is mounted on the stator.

With the electromagnets on the stator, they are very easy to cool.

The stator is stationary in space by definition and therefore its current.

The stationary part of an electric motor is the stator.

The bottom half rests in the fixed part of the motor, or stator.

The difference with a three-phase motor is in the stator.

You can have a lot of electromagnets on the stator for more precise control.

There are 16 electromagnets inside the stator that can be turned on or off by software.

The armature can be on either the rotor or the stator.

The stator plate cannot be made of a single casting, as it is kilometres long.

Chunking - where the rubber across the top of the stator has been worn away.

Care must be taken to compensate for stator swelling.

Stator: he who has the power of establishing, instituting, founding.

Once again, a simple thin aluminum sheet would serve as an appropriate stator plate.

The output of the dynamo is then taken from the stator coils.

The stator is formed by a cover enclosing the rotor.

The gap between rotor and stator is also made as small as possible.

During start-up the resistors reduce the field strength in the stator.

Thus if the number of turns is equal, the rotor has the same voltage as the stator.

It also has a rotor element and a stator.

Such devices require care in construction to meet the necessary precision to make use of these motions within the stator.

These had a two-pole stator with a field winding.