cap screw

The toothpick was pulled out and a cap screwed on.

Make sure both caps screw on tightly before you insert the powder.

For this reason, never move an oxygen tank around without its valve cap screwed in place.

The most common form made this way is a hexagonal socket in the end of a cap screw.

First, check that the lever cap screw is tight.

Hex cap screws are noted for the extra torque they provide.

What are the dash marks found on the heads of hex cap screws?

O is the treadle's "divided head, with the upper division or cap screwed down.

Within the central cylindrical area, one or several socket head cap screws fasten the shell to the arbor.

The arm, oversized and still in square section is located on the back upright, and held by a capped screw from behind.

The cap screw costs $13.50 and the cap turner $15.40.

The trigger assembly can be easily removed for cleaning by undoing two socket-head cap screws.

If you look at the head of a hex cap screw, you might notice lettering or dash marks.

He then took an Allen wrench and screwed the cap screw into the buckle, the head fitting into a recess.

Applications include the heading of bolts and cap screws and the finishing of cold rolled steel.

A cap is used like plug, except that the pipe cap screws or attaches on the male thread of a pipe.

If adjustment is needed, loosen or tighten the lever cap screw that captures the cap and blade and protrudes from the frog.

Hex head, or hex cap screws differ from the others because they require a special driver to be installed; they're used when extra torque is needed.

Socket Cap Screws, also known as Allen head screws, are reliable and durable and are used in many applications.

Shells were brought to the room fully loaded, and all that was left to do was for the fuse to be added and the shell cap screwed down.

(Popular Science magazine would note in 1946 that "Cap screws and setscrews with heads recessed to take hexagonal-bar wrenches are coming into increasing use.")

The Lasersaur carriages are build from standard-sized ball bearings (with nylon coating), cap screws and custom-cut acrylic or metal pieces.

The relief is mounted to the wall with four socket cap screws, one in each upper corner and one on each side approximately six inches from the bottom.