chamfer

What we're after is a nice chamfer, about a quarter inch.

In wheels 0.15 mm thick or less, a single chamfer is allowed on the bridge side.

"Chamfer" is a term commonly used in mechanical and manufacturing engineering.

The stopped chamfer template has not to my knowledge been marketed, readers who want one will just have to make their own.

If this is done carefully, the ends of the stopped chamfer template could be used as a useful small square.

I was allowed only a small chamfer.

The roof beams are decorated with chamfer and lamb's tongue moldings.

The chamfer of a Simon bow follows a large, generous curve which can be seen from the profile.

A chamfer is a beveled edge connecting two surfaces.

A graduated chamfer can convert a linear element into a vector, having magnitude and direction.

This chamfer also has the practical benefit for a table stretcher of reduced wear from feet on an otherwise sharp edge.

Fillet and chamfer, edge features designed to reduce burrs.

This chamfer allows the die to ease onto the blank before it cuts a sufficient thread to pull itself along.

An interior or exterior corner with an angle or type of bevel, is called a "chamfer".

If the surfaces are at right angles, the chamfer will typically be symmetrical at 45 degrees.

The fluted countersink cutter is used to provide a heavy chamfer in the entrance to a drilled hole.

Later guns have a shorter, sharp-angled chamfer.

Special tools such as chamfer mills and chamfer planes are available.

Three generations later, fortunes founded on sugar alone were lost and the current Lord Chamfer retired with his wife to the dower house.

Use either a chamfer or a round-over bit to minimize the amount of exposed end grain, then seal the ends with preservative.

Both structures are made of quarry-faced random ashlar limestone on a cut and smooth finished chamfer stone base.

It would be a chamfer knife, for smoothing and leveling the tops of barrel staves after they were hopped together, among other things.

The chamfer effect appears to give the building a more massive look at ground level and a more delicate look at the roof line.

And "chamfer" describes a beveled or cutaway corner, which the new 1,776-foot Freedom Tower has abundantly.

Bevel cutting -cutting a board off to form a bevel or chamfer, rather than a square edge - is equally simple.

Its simple entrance door in the west wall is chamfered.

It is almost square in plan with the forward facing corners chamfered.

Inside, chamfered wooden posts support a gallery on three sides.

The corner of the house is chamfered and has a blank two-window range.

Another noticeable change to the base is that its corners would be chamfered and tapered.

The two top courses are chamfered towards the dome.

The small, diagonal front chamfered gate is also built in wrought-iron.

The two pieces have chamfered ends (60 to axis).

Its corners were slightly cut away, or chamfered.

Slabs were sometimes chamfered at one or both ends to fit into the mortises.

A wood front porch has chamfered posts and carved balusters.

The cross is also on Calvary steps and the slab has chamfered edges.

Often the edges of shafts and holes are chamfered (beveled).

The front gallery, running the length of the home, has chamfered gallery columns.

The case mouth is chamfered on the outside to fit flush into the forward cannelure.

The plinth and string course are both chamfered.

There is an arch to the tower, which is chamfered and moulded.

H: a disk with the edges chamfered off.

The first period house is distinguished from later houses by its exposed (often decorated or chamfered) frame in the interior.

The arches have chamfered orders, and the hood-mouldings are also ornamented.

The rim is chamfered and has slight damage.

The basement forms a rusticated plinth, the front being battered and chamfered.

A small porch features chamfered columns with a Greek Revival character.

The interior features chamfered posts, closely spaced joists, and fire doors.