chopped strand

Fully reinforced with chopped strand fibre, 2mm dry film thickness.

Chopped strand mat is the most widely used form of glass reinforcement, especially in sheet materials.

Apply Barrierflex with chopped strand mat over the joints between the sheets.

A chopper gun is used to deposit the chopped strand reinforcement and resin.

One piece moulding hand laid chopped strand mat.

Polyester resin and chopped strand mat are used.

Using chopped strand mat gives a fiberglass with isotropic in-plane material properties.

Very good for placing over Chopped Strand Mat to make a smoother repair.

Chopped strand mat, a form of glass-reinforced plastic (fiberglass)

Production is achieved through the use of chopped strand mat (CSM) technique.

It has been laid up with chopped strand/mat, with a specially formulated, high impact strength resin.

The mixer is then switched to slow speed and fibre in the form of chopped strand (length approximately 13mm) is added slowly.

Chopped fibreglass strands or chopped strand mat can be added to some of the above multi-axial fabrics.

The hull is constructed of chopped strand mat and woven rovings with an isopthalic gelcoat.

Chopped strand mat or CSM is a form of reinforcement used in fiberglass.

The glass can be in the form of a chopped strand mat (CSM) or a woven fabric.

Materials are now sprayed into the interior of the mould with a special gun that combines the resin and chopped strands of glass fibres.

Smaller tanks can be made with chopped strand mat cast over a thermoplastic inner tank which acts as a preform during construction.

Description of Goods -Slivers, rovings, yarn and chopped strands:

Pontoon to be covered with 2 layers of 300gsm Chopped strand fibreglass matting and fibreglass resin.

It may be continuous fibre (e.g., rovings), woven fabric, nonwoven mat or chopped strand.

The glass fiber may be randomly arranged, flattened into a sheet (called a chopped strand mat), or woven into a fabric.

Random, continuous/chopped strand mat.

It was then relaminated with two layers of chopped strand matt applied wet on wet with vinylester resin.

Glass fibre reinforcement is introduced into the mould in chopped strand mat or woven fabric form, or deposited in-situ using a chopper gun.