club hammer

Lower the slab in place, then tap down with the handle of a club hammer.

He kept one arm crooked over his head, protection against the clubs hammering at him.

The club hammered into his thigh and agony lanced him.

This fireplace succumbed to the blows of club hammer and bolster.

A club hammered down, striking sparks from the barrel.

First, cut a suitably-sized hole in the interior wall leaf, using bolster and club hammer.

Use a rubber hammer or the handle of a club hammer to level each slab.

Tap in place with the club hammer handle and check with a spirit level as work progresses.

Note the use of club hammer handle.

To increase the force, stone chisels are often hit with club hammers, a heavier type of hammer.

Gorgon broke through the shield-wall, one huge club hammering down on the King's shoulder.

Groll clubs hammered that old monster's skull, and not a second too soon.

A club hammered at the door.

I don't think Wonga.com send round a thug with a club hammer when you default.

Their weight is an advantage, as they almost level themselves, needing only the minimum of tapping down with the handle of a club hammer.

Remove any nibs with a cold chisel and club hammer and dust clean.

Cut away the existing tiles with a broad-bladed steel chisel (bolster) and club hammer.

Pieces which are too large can be broken by laying the slab on a bed sand, then topping smartly with a club hammer.

With the exact position established, the outline can be scored with sharp blows from a club hammer and bolster chisel.

A lump hammer or club hammer is a heavy one-handed hammer with a double-faced head.

Hairy Dave swung the five-pound club hammer wildly in the direction of the Victorian marble fireplace.

Also called club hammers and lump hammers, they are available in two-, three- and four-pound weights.

Chasing solid walls is done with a bolster chisel and club hammer, and it is important to keep the cables vertical so that you know where they are.

Edward Ryman, 58, twice smashed his wife with a club hammer and used a 'do it yourself garotte' to strangle her, Nottingham Crown Court was told.

Cold chisels are designed to be struck with a hammer; either a machinist's hammer (often called a ball-peen hammer) or a small sledgehammer (sometimes called a club hammer).