cooling coil

It's hidden in some trees, but I can see the cooling coils.

If you point a flashlight into the cooling coil, does light shine through the other side?

That means the cooling coils filled with refrigerant can be smaller.

For cooling coils, chilled water and refrigerant are most common.

Are both sides of the cooling coil visibly clean?

Check any insulation near cooling coils for wet spots.

Clean cooling coils regularly to ensure proper airflow and heat transfer.

Under certain conditions of temperature and humidity, ice can form on the dehumidifier cooling coils.

Terminal units may also include either, or both, a heating or cooling coil.

The cooling coils on the walls and the spreading stains on the floor were painted.

Cooling coils will also employ eliminator plates to remove and drain condensate.

It was a small domed structure with a bunch of cooling coils on the back of it.

As dust collects on the cooling coils, mold, like this cladosporium fungus, may begin to grow.

However in an air conditioner, air passes over the cooling coils (the evaporator) and then directly into the room.

An alternative design senses the impeded airflow, and shuts off the cooling coils in a similar manner.

The heat removed via evaporation lowers the temperature of the cooling coil closer to the lambda point.

On those systems, after the moisture is removed from the make up air, a cooling coil is used to lower the temperature to the desired level.

The solution must be kept below 40 C (by cooling coils) to prevent the undesired formation of sodium chlorate.

Remove standing water under cooling coils of air handling units by making sure that drain pans slope toward the drain.

Liquid refrigerant from the surge tank is pumped through the cooling coils at sufficient pressure to avoid vaporization.

Ensure that the air conditioner can maintain a temperature drop of about twenty degrees as the air passes through the cooling coils.

After each layer had sufficiently cooled, the cooling coils were cut off and pressure grouted by pneumatic grout guns.

The pressure in this tank is maintained at the saturation pressure for the desired temperature for the cooling coils.

By the 13th century, the development of the cooling coil allowed the isolation of nearly pure ethanol by distillation.

The exchanger keeps the cooling tower water separate from the coolant flowing through the cooling coils.