cutting head

Because of its round cutting head, you can cut in any direction.

Bump feed cutting head - advance line on the go.

The cutting heads can include a punch, drill or torch.

If the cutting head may be controlled, it is designated as the Z-axis.

For each pair of numbers the operators would move the cutting head to the indicated spot and then lower the tool to make the cut.

A clogged bore creates back pressure on the cutting head, slowing production.

The cutting head died, and the power bore operator backed away from the vertical shaft.

Moving material lasers have a stationary cutting head and move the material under it.

The tapes contain instructions that guide the machines' cutting heads to shape components.

Each 1 degree rotation of the controls produced a 0.0005 inch movement of the cutting head.

The Pro uses a 11.4-inch-diameter cutting head to trim greenery, and it cleans up after itself.

"Both the cutting heads for the laser are shot," Nylan explained.

Some models can convert into edging mode by turning the cutting head 180 degrees with the touch of a button.

An eye-searing dazzle flickered as she powered up the cutting head and brought it to bear.

It was faster, but dismantling the cutting head to clean it took up the time saved, plus some.

Some profile cutters use a cutting head reminiscent of a spindle router.

These machines employ two wide, rotating cutting heads, one above the stock and one below it.

Some, more expensive, jointer models contain a spiral, or helical, cutting head.

A shaft with so much force behind it pierces the body and comes out on the other side with its broad cutting head all bloody.

In the Westrex system, each channel drives the cutting head at a 45 degree angle to the vertical.

Pancho hesitated as she held the laser's cutting head next to the curving metal wall.

None of them had experience in cutting heads; they would have bungled it, and indeed, they had no time.

It consists of a cutting head at the end of a long shaft with a handle or handles and sometimes a shoulder strap.

He invented the moving-coil disc cutting head, which not only got around the patent but offered greatly improved sound quality.

The design also makes it a snap to tilt the cutting head up to 90 degrees, letting you reach tough-to-access areas without straining.