cutting wheel

George laid down the diamond cutting wheel he had been working on.

A sharp cutting wheel is drawn across the tile face.

Each end has its own small, round cutting wheel.

Material picked up by the cutting wheel is transferred back along the boom.

At the front end of the shield a rotating cutting wheel is located.

When grinding is impractical, you can cut the bolt off with a cutting wheel.

It consists of a cutting wheel and a roller.

At its end was a rolling V-shaped cutting wheel of hardened steel.

They tracked their ways across the flawless glass like glaziers' cutting wheels.

Wrights have Power cutters for either steel or concrete cutting wheels.

It was close enough now to see the diamond cutting wheel glinting in the creeping sunlight.

Cutting wheels will also saw through electrical conduit or metal tubing, especially where other tools do not reach.

To use the cutter, place the pipe in the jaws and tighten the handle to engage the cutting wheels.

Because of the excellent edge left by the cutting wheel it was soon cleaned out, pipe installed and reinstated.

During the 18th century it became slightly industrialized with a pottery factory and a sanding or cutting wheel plant.

The top of the can was cut by pressing the cutting wheel into the can near the edge and rotating it along the can's rim.

After each rotation, tighten the movable jaw so the cutting wheel digs deeper.

Although designed with a narrow opening to the cutting wheels, shredders still pose a danger to pets and small children.

Place the pipe in the pipe cutters with the cutting wheel on your pencil mark.

It dough is rolled out and then cut into strips, in Iceland often with a special cutting wheel called a kleinujárn.

Cutting the panels is very easy with the use of a 4 inch grinder and narrow cutting wheel.

A breakthrough design came in 1925 when a second, serrated wheel was added to hold the cutting wheel on the ring of the can.

These all tend to clog the cutting wheel more than steel & cast iron, but with special techniques it is possible to grind them.

Rotate the cutter around the pipe, tightening the handle after each revolution so the cutting wheels bite deeper.

These resemble pipecutters but contain knurling wheels rather than cutting wheels.