external gear

Unlike external gear pumps, however, the lobes do not make contact.

Also available as remote version for connection to external gear selection linkage.

An external gear is one with the teeth formed on the outer surface of a cylinder or cone.

A gear shaper is a machine tool for cutting the teeth of internal or external gears.

For external gears the number of teeth on the cutter is limited only by the size of the shaping machine.

Each joint consists of a 1:1 gear ratio internal/external gear pair.

Pulsar allows totally free signal routing between all software components, the drivers and even your external gear.

The sun gear then drives the planetary gears assembled with the external gear ring to operate.

This process produces internal gears, external gears, and integral gear-pinion arrangements.

Hepco's largest ring system - 1033mm in diameter - was selected with an external gear driven by a pinion from an electric motor.

The tooth flanks and outer diameter of the external gear are crowned to allow for angular displacement between the two gears.

EX (external gear mechanism)

Indexing fixtures can disengage the drive worm, and be attached via an external gear train to the machine table's handle (like a power feed).

Lobe pumps are similar to external gear pumps in operation in that fluid flows around the interior of the casing.

The planetary gear housing features external gear teeth and can be rotated by a motor and worm gear.

Space was full of the disc-shapes; thin, delicate-looking Lights with their projecting external gear, and thicker, smoothly armored Mediums and Heavies.

This adjustability, coupled with the use of specialized cutters and toolholders, enable the operator to cut internal and external gear tooth profiles, splines, dovetails, and keyways.

A gear motor (external gear) consists of two gears, the driven gear (attached to the output shaft by way of a key, etc.) and the idler gear.

For reliability, it is rare to use an external drive mechanism, either a separate belt drive or external gears, although camshaft-driven pumps often rely on the same timing belt.

Skiving can be applied to gear cutting, where internal gears are skived with a rotary cutter (rather than shaped or broached) in a process analogous to the hobbing of external gears.

The whole set of planetary gear system revolves on its own axis and along the external gear ring where the output shaft connected to the planetary carrier achieves the goal of speed reduction.

Most of the large gyroscopes, thermal control system components and other external gear is intended to sustain operations of the station by a US-led partnership of 14 nations well beyond the shuttle's approaching retirement.

A full chain guard also keeps the drive train (chain and external gears) clean and efficient by excluding water, mud, and grit which could splash onto the chain and front chainring, increase wear, and reduce drivetrain efficiency.

Advanced setups include cutting the lower portion of the chassis, changing the motor arrangement significantly (single motor setup with an external gear reduction unit), or changing the length of suspension links to modify caster angles and distances between axles and the chassis.

There are two main variations; external gear pumps which use two external spur gears, and internal gear pumps which use an external and an internal spur gears (internal spur gear teeth face inwards, see below).