flanged joint
flange joint

These amount to some 35 km of pipe, typically 1m lengths with flanged joints.

The pressure mains were made of cast iron, and the flanged joints were sealed with gutta-percha rings.

This is mainly as a result of the construction methods used (flanged joints on the barrels and standard steel pipe for the flue tube).

A flanged joint is rigid and can bear both tension and compression as well as a limited degree of shear and bending.

Similar red lead-based compounds were also widely used as a jointing compound in engineering, to form steam- or oil-tight flanged joints in pipework.

Nau The JOINT Computer program for analysis of gasketsealing stresses in flanged joints. 11pp. 9 figs.

These amount to some 35 km of pipe, typically 1m lengths with flanged joints.

Gaskets are used for sealing of flange joints.

A flange joint is a connection of pipes, where the connecting pieces have flanges by which the parts are bolted together.

The intermediate shell connects to the end shells by flange joints and the total length of shell is 7.2 m.

Ductile Iron pipe is available with a rubber ring jointing system or fixed screwed flange joints.

The pressure mains were made of cast iron, and the flanged joints were sealed with gutta-percha rings.

This is mainly as a result of the construction methods used (flanged joints on the barrels and standard steel pipe for the flue tube).

All flange joints are of this nature; some, however, are provided with a means for tightening the center-pin in the middle portion of the joint.

Duct joints must be welded flange joints, butt joints, or overlapping joints.

A flanged joint is rigid and can bear both tension and compression as well as a limited degree of shear and bending.

Similar red lead-based compounds were also widely used as a jointing compound in engineering, to form steam- or oil-tight flanged joints in pipework.

To form a pipeline, each segment of pipe is joined together with so-called flange joints - rims that are bolted and sealed together at each end.

On pipeline systems, where flange joints vary in size, pressure and hazardous nature of product, the torque figures can be set precisely and consistently to prevent leakage.

Nau The JOINT Computer program for analysis of gasketsealing stresses in flanged joints. 11pp. 9 figs.

Flange joints: on large steel spudguns, pipe and fittings are sometimes bolted together by means of flanges with a gasket sandwiched between them to provide an airtight joint.

Intn'l ISO/DIS 8483-96 Glass-reinforced thermosetting plastics(GRP) pipes and fittings - Test method to prove the design of bolted flange joint.

Because the lining is under considerable external pressure, to prevent water leakage lead strip was inserted between the segment flanges and subsequently caulked by knocking back the edge of the strip into the flange joints.

Weld splatter or weld runs across the contact wall surface, offset flange joints, protruding gaskets, recessed ports and projecting intrusion near the outlet are all highly effective at opposing the slip of material on the wall contact surfaces.