furnace temperature

Other applications can be considered provided the furnace temperature is greater than 850ºC.

The higher the furnace temperature, the faster the steam production.

Changes in air design have increased furnace temperatures.

Hot blast also allowed higher furnace temperatures, which increased the capacity of furnaces.

Product and furnace temperatures (up to 24 thermocouple points) are catered for.

It was later improved by making it double acting, which allowed higher furnace temperatures.

The furnace temperature had to be changed.

Under the blasts of furnace temperature, the rubies glowed more vigorously than ever.

Flame temperature, air preheat and furnace temperature are all interrelated.

The advantage of the bloomery technique is that iron can be obtained at a lower furnace temperature, only about 1,100 C or so.

This kind of air system with increased dry solids managed to increase lower furnace temperatures and achieve reasonable reduction.

He was always stoked to furnace temperature.

These "hot potatoes," as they were nicknamed, were pre-heated to furnace temperatures before being fired at the advancing ships.

Baryte (BaSO4) Used in glass as an active flux in furnace temperature control.

Heating is provided by 27 wire spiral resistance elements supported on ceramic tubes and are separated into three control zones to provide furnace temperature uniformity.

As boiling is random, the boiler is limited in both its evaporative capacity and also its maximum furnace temperature.

Such coals may contain up to 70% water and ash, yielding lower furnace temperatures and requiring larger induced-draft fans.

It has been observed that some quartz or granite aggregate concrete has a tendency to spall when exposed to furnace temperatures.

Blast furnace temperatures mellowed to merely scorching, and the deserts became tolerablean opportunity to cross their trackless wastes.

Raising the furnace temperature improves the efficiency but complicates the design, primarily by the selection of alloys used for construction, making the furnace more expensive.

This frees the iron, which is molten at the high blast furnace temperature, and trickles down to the base of the blast furnace.

If the ash fusion temperature is less than the furnace temperature then that type of furnace is called a wet bottom furnace.

As the result of this superior heat transfer, the same amount of hydrogen can be produced at lower furnace temperatures meaning less fossil fuel is consumed in the process.

The high furnace temperatures in coal fired power stations are beneficial in reducing the environmental impacts such as emissions and leachates, relative to other methods of disposal.

Numerical solutions have been obtained for the pyrolysis of a beech wood cube with different initial moisture contents heated at various furnace temperatures up to 1000 oC.