fuse holder

They can buy an in line fuse holder or mount it on the circuit board.

He thrust the loaded fuse holder back into its slot.

Cutting the hole for the bank of fuse holders was trivial.

A lamp base is too short to contact the bottom terminal of a fuse holder.

A small screwdriver or coin is required to remove the fuse holder.

Final assembly will start when I can find some fuse holders for motor mounts.

We inspected the fire damage, they had replaced the main fuse holder, I expect the old one wasn't man enough for the job.

The circuit can also be opened manually by pulling out the fuse holder using a hot stick.

I dismantled the fuse holder, cleaned the connections up a bit and power appeared to be restored.

One size will lock out most types and size of Fuse Holders.

A detachable power cord connects to a push-lock fuse holder.

One in recently had a bent nail squashed into the fuse holder to ensure total destruction.

Carrier told the safety agency that, starting last Dec. 20, it began manufacturing units with a new fuse holder.

Open and remove the plastic fuse holder.

He said empty fuse holders were found and described them as like a fuse but not an explosive device.

Most data sheets quote most fuse holders as being rated at 10 amps.

These Fuse Holder Strips are easily cut on site to required number of poles.

Some are time delayed, slow reacting, or have leads for terminals used in circuits without a fuse holder.

This quenches any arc in the fuse holder.

The electrical wiring dated from that era and utilized the old-fashioned ceramic type fuse holders.

A bad fuse holder was replaced.

Corrosion can occur in the fuse holder on bikes used in all weathers.

The metal end caps of the fuse and the fuse holder should also have a coating applied to them.

Insert and secure the two fuse holders, the spiral lead cable protectors and switch.

Blade type fuses often require the use of a special purpose extractor tool to remove them from the fuse holder.