gland nut

Packing material, revealed beneath the gland nut, was removed for treatment.

Pump grease into the top & bottom gland nuts before tightening.

Tightening the gland nut will sometimes stop a leak.

Turn off both valves and undo the gland nut.

Everything from a gland nut to a complete Big-Bore screamer!

This has of course been calculated so the distance from the gland nut to the torque wrench drive is very precise.

With the cover removed, tighten the gland nut at the base of the spindle with a spanner.

Loosen the grey plastic gland nut and remove, together with the lamp and the rubber O ring.

Loosen set screws and tighten gland nuts quite snug and until leaking stops.

In taps, replacing the tap washer and tightening the gland nut will both contribute to stopping water hammer occurring.

Peter Gilbert received $1,620 for the design and construction of an adapter to fit the gland nut wrench used in repairing submarine valves.

A gland nut and packing material prevented ingress of alien material through the "D" valve shaft.

All valves, packing gland nuts, closures and flanges should be checked using leak detection solution or ultrasonic instrument.

Loosen the upper and lower gland nuts of the water entry swivel, remove the 3/8-inch bolt from the shaft, and pull out the quill.

He sees the capstan head, beneath the head the shroud covers the gland nut, the spindle, the headgear nut, the jumper.

With all the squeaking that was going on, I expected very rusty threads, which often occurs if the sealant on the gland nut is damaged in use.

The gland nut allows the packing material to be compressed to form a watertight seal and prevent water leaking up the shaft when the tap is turned on.

Also known as gland nut or slip-joint pliers, these pliers, unlike other gripping wrenches, are useful for turning nuts as the serrations will grip the nut safely.

The gauge glass on a boiler needs to be inspected periodically and replaced if it is seen to have worn thin in the vicinity of the gland nuts, but a failure in service can still occur.

Your use of it indicates acceptance of our disclaimer Visit the latest feature-packed version Leaking tap See safety See Regulations Older style taps are fitted with a gland nut holding in watertight packing around the spindle.

Stripping the hub requires the use of a special tool, this is a tool that is used to lock the hub while the hub nut is removed, it can also be used to remove the engine flywheel gland nut.

Muttering some proverb about time lost never being regained, McCrimmon drew forth a ten-inch Stilson wrench, expertly calculated with his eye the gauge of the gland nut on the taps and was adjusting the spanner when a low, sibilant voice behind him said 'Meester!'