heat input

Is the heat input rate the same for the experiment done with/without salt?

Your heat input by radiation will depend upon where you are in space.

During very large activity, however, this heat input can increase substantially, by a factor of four or more.

With less heat input, the net result was that the reactor would cool.

It becomes very small so that the sample's increase in temperature for a given heat input may be relatively large.

The source of energy in a heat engine, is a heat input.

You disagree with my conservative estimate of 9kW heat input, but offer no supporting argument!

Heat input for the table is 7.38kW, and it comes with adjustable feet on stainless steel legs.

This will calibrate the apparatus change in temperature against a given heat input.

More bonds have to be broken, and that requires more heat input.

The level of heat input also affects weld quality.

And he had never been comfortable with such a major element of the terraforming's heat input being so fragile.

Pulsed current is particularly useful for these applications, as it helps limit the heat input.

The heat capacity, which relates heat input and temperature change, is discussed below.

When a smaller electrode is used in conjunction with lower heat input, its versatility increases.

A single deep connection to the magma supply maintains the heat input by convection.

Excessively high heat input, on the other hand may be detrimental to the final properties of the weld.

Continued heat input will then "super" heat, the dry saturated steam.

Arc welding falls between these two extremes, with the individual processes varying somewhat in heat input.

Heating inputs were reduced as the ratio of floor area to roof area was increased substantially.

In addition, heat input depends upon the infrared radiation impinging on the bottle samples - again something that is difficult to control simply.

To calculate the heat input for arc welding procedures, the following formula can be used:

The module takes into account air/ground energy and mass interactions including solar radiation and forest fire heat input.

This grants the operator additional control over the heat input into the weld, but requires significant skill to perform successfully.

Also the use of regeneration in the Ericsson cycle increases efficiency by reducing the required heat input.