Additional examples are adjusted to the entries in an automated way - we cannot guarantee that they are correct.
The aluminum frame was later reinforced with a hex bolt above the trigger guard.
These fasteners are very similar to hex bolts.
It was a hex bolt, head-stamped with the letters CE.
The spheres brightened, growing in intensity until crackling hex bolts shot from each like twin spears of light.
A hex bolt rather than a rotating dial tightens or loosens the palm shelf.
Fitting the drive shafts was luckily a straight forward operation requiring a little sealant, hex bolts and arm work.
Jim Leyland is a factory of a man, with hex bolts for elbows and smoke plumes from his Marlboros.
Hex (or Allen) keys are used on the various hex bolts on the stem, top cap and handlebars.
Nocturne can also fire "hex bolts," destructive projectiles made up of extradimensional energy from the dimension through which Nightcrawler teleports.
Please note, we cannot grind th einside of hex bolts, Socket Caps or hose clips, only brighten them.
In those applications structural heavy hex bolts are to be used, as defined by ASTM A490, even though they have the same strength.
Scarlet Witch is able to manipulate probability via her "hexes" (often manifesting physically as "hex spheres" or "hex bolts").
Bracing her feet, the Scarlet Witch cast hex bolts in a half dozen directions around her, catching the six nearest advancing robots square in the solenoids.
Torx screws are preferred for the superior torque: it is easy to strip the socket of a hex bolt by overtightening it, leaving a rotor that is hard to remove.
Rim mounted vertical drop deadbolts should be installed on these doors with a minimum of 10.6cm (4 1/4") length carriage or hex bolts mounted through the door and into the escutcheon plate.
The sight is mounted directly to the barrel as normal, however, the design allows the barrel and sight to be removed from the body of the rifle by undoing the two hex bolts, accessed from under the body.
Other benchmarks: TP2: SS hex bolt set in white epoxy located 190ft N on shoreline road from TP1 and on top of SW corner of S water tank behind Government Office Building.
Save the rectangular washers from under the running boards. 10. Remove the body and save the rubber mounting strip from the edge of the chassis, and the two l0 mm hex bolts and rubber pads that secure the body to the top of the front axle beam.
Forging dies - upper barTrim & pierce - upper barForging dies - lower barTrim & pierce - lower barUpsetter dies for spill plate boltsUpsetter dies for M30 transverse hex bolts existing Two transverse holes were machined by sub contractor.