lift valve

Closure by means of a positive lift valve to avoid jamming.

Alternative gas lift valves and designs can be evaluated to optimize workovers.

In 1951 the sidepocket mandrel was developed for selectively positioning and retrieving gas lift valves with wireline.

In the latter case there should be a dual string packer, or equivalent device, located above the uppermost gas lift valve in the production string.

While injection may, on occasion, be through a hole punched in the tubing wall, common practice requires the installation of gas lift valves at a number of points.

The Pearson was affected by the gas purchaser's compressor repair and our Fox well required a workover to repair a gas lift valve.

Hargrave builds Engine No. 33, a three cylinder fixed radial with cam lifted valves driving contra-rotating propellers, one in front of engine one behind.

One way that variable displacement may be accomplished is by using multiple lifting valves on the suction side of the compressor, each plumbed to a corresponding location on the discharge.

These measures can protect against other secondary events, such as environmental damage from reservoir flow through failed gas lift valves, but these are secondary to the main purpose of protecting health and safety.

Due to the strong flowrate and high flowing pressures, a snubbing unit is currently installing the tubing string and gas lift valves which is expected to further improve production from the well.

The side pocket, typically 1" or 1 " diameter is designed to contain gas lift valve, which allows hydrocarbon gas from the A annulus to be injected into the flow stream.

The model was used to predict system performance to the separator for 32 different production scenarios and although the oil producers were naturally flowing the model included gas lift valves for future production simulations.

Conventional gas lift valves are attached to gas lift mandrels and wire line retrievable gas lift valves which are set in side pocket mandrels.

All annuli will naturally be filled to some level with brine or other fluids from the completion, though the 'A' annulus may have gas down to the lowest gas lift valve if the well is gas lifted.

Some completion components may be deployed and retrieved on slickline such as wireline retrievable safety valves, battery powered downhole gauges, perforating, placing explosively set bridge plugs, and placing or retrieving gas lift valves.

Clerk himself states that "It is not a compressing pump, and is not intended to compress before introduction into the motor, but merely to exercise force enough to pass the gases through the lift valve into the motor cylinder, and there displace the burnt gases, discharging them into the exhaust pipe."