linear dimension

You and I have lost half our linear dimension in every direction.

The change in the linear dimension can be estimated as:

Bruce seemed to have side-stepped any specific mention of the linear dimensions.

In general, area and volume do not scale as the second and third powers of linear dimensions.

He found it particularly interesting because of its great linear dimension, the numerous population and distinctly elongated form.

It is assumed that social values, which are also placed on a single linear dimension, might be assigned to each variant.

When linear dimensions are doubled, the energy density in radiation falls by a factor of sixteen.

The ship and I and you have been miniaturized to about half our linear dimensions."

Where the curves in Fig. 1 a peak, objects have typically spread to 5-10 times their initial linear dimensions.

I can focus down to a cross section of two millimeters or up to a decameter, and about twice that for the linear dimension.

This is a linear dimension, typically in micrometers.

Linear dimensions of gaps were comparable to the geometrical size of the event.

Two examples are linear dimensions and feature control frames using a datum reference (both shown above).

Cartesian coordinates work well enough for regions with linear dimensions small relative to the radius of the surface.

However, as the typical linear dimensions are not significantly larger than the mean free path, such an approximation is only marginally applicable.

As a rule, the plane mapping allows to obtain a pattern with linear dimensions 1-2% less than corresponding spatial lines of a final surface.

Halving a linear dimension increases the magnetic field fourfold.

Nanobe-(n) Any living or self-replicating system smaller than 500 nanometers in linear dimension.

If the part is anodized on all sides, then all linear dimensions will increase by the oxide thickness.

Libralces gallicus was 1.25 times larger than the Alaskan moose in linear dimensions, making it nearly twice as massive.

The subset of X is equal to the relation of photon fluctuations in a linear dimension.

As stated before, the polarization of the slot is due to its feed which is generally across the smallest linear dimension.

The group found that linear dimensions could be calculated to within 0.5mm and a cross-sectional area within 5% and volume within 3-7%.

Zero force TM will only be sensitive to changes in the bulk that are expressed as a change in a linear dimension of the material.

Dynamically similar gaits are those between which there are constant coefficients that can relate linear dimensions, time intervals, and forces.