liquid phase

Just let the container warm until some liquid phase appears.

This is usually a solid to liquid phase due to the small volume difference between these states.

The two liquid phases are almost completely insoluble in one another.

Once the liquid phase forms, the free energy conditions quickly change and favor melting.

Below the bottom trace, only the liquid phase is in equilibrium.

So a tank of nitrogen gas at room temperature will never form a liquid phase.

The value of K is usually of interest in the liquid phase.

The contact time between the gas and liquid phases is very short, limiting absorption.

The molecules are consequently held back in the liquid phase and the vapour pressure is lower.

For example at low enough temperatures the two isotopes separate into different liquid phases.

This also involves the separation of oily and water liquid phases.

The reaction occurs in solid and liquid phase only, without releasing any gas.

All of the primary coolant is in the liquid phase during normal operation.

It is the standard measure for liquid phase applications.

Some years ago, in the early '70s, a Russian chemist, believed that he had discovered a new liquid phase of water.

Only the liquid phase can freely spread on the surface to form a monolayer.

Some of the techniques available for measuring the liquid phase include:

At the melting point the solid and liquid phase exist in equilibrium.

So after the electrolyte solution is melted, only the liquid phase remains.

Both solid and liquid phases are present and in equilibrium.

The liquid phase has a higher internal energy than the solid phase.

Samples are stored at the liquid phase of nitrogen.

In Figure 9.9 this would occur if the boundary between the solid and liquid phases were to move to the right as pressures get large.

The students may not have anticipated that the volume is the same no matter what the liquid phase is.

At 1 atm pressure it goes directly from the solid to the gas with no intermediate liquid phase.