nominal diameter

My measurements suggest both pieces are made to a nominal diameter of 24.00mm.

A nominal diameter may also be derived from the volume of the pebble.

The higher the grade, the lower the allowable variance from the nominal diameter.

The culvert that the flap is required on has a nominal diameter of 600mm.

The existing culverts had a nominal diameter of 900 mm.

Copper clad only, incorporating driving head and point, nominal diameter 19mm.

Basic size: the nominal diameter of the shaft (or bolt) and the hole.

The nominal diameter is achieved some small distance (the "gauge length") from the end of the pipe.

The nominal diameter shall be marked to the nearest one thousandth of an inch.

This diameter tolerance varies, within each grade, based on the nominal diameter.

A 1650mm nominal diameter Sydney Water sewer, up to 9 metres deep, needed rehabilitation.

For small nominal diameters, protective tubes prevent mechanical damage during installation and operation.

This standard only applies to short screws and bolts with a nominal diameter between 3 and 10 mm.

Minimum internal volumes nominal diameters: Volumes that are too small may fill up.

The length of the VAS shall be one-half nominal diameter.

Part 2 defines the mechanical properties for coarse threaded nuts up to an M39 size and a height of at least half the nominal diameter.

Part 7 defines how to perform torsional tests on bolts and screws that have a nominal diameter less than or equal to 10 mm.

The pipe produced at the Montreal facility range between 0.5 in. and 4 in. inclusively in nominal diameter size.

Note that the nominal diameter of PE pipes refers to the outside diameter in accordance with international practice.

The nominal diameters for the couplings range from 1/8 inch to 6 inches and they can be manufactured in full and half coupling variations.

A detachable solid handle, of nominal diameter d, fits through these holes with a diametral clearance of 1%.

Australian Standard 1214 specifies the following oversize tapping allowances: Nominal diameter of internal threads.

The diameter of the cleaning balls is only slightly bigger than the nominal diameter of the condenser tubing.

Although both metric, European and Australian are not compatible and pipes of identical nominal diameters have quite different dimensions.