porosity

By this process the tiles created have very low porosity.

The increased rate is a result of the greater surface area associated with porosity.

Thus creating a single mass making them extremely hard with low porosity.

In these cases, very low porosity is desirable and can often be achieved.

Porosity is important, but, alone, it does make an aquifer.

Porosity might prove to be a problem even for some of the alternative methods, however.

If neither of these are the case then most likely the porosity is due to gas formation.

First, as you pointed out porosity is a problem.

Fire flood works best when the oil saturation and porosity are high.

Porosity is a measure of how the paper responds to a liquid.

This bulk density can then be used to determine porosity.

Yet, we are quite obviously considering a proposal that would increase this porosity.

I don't think fingernail has quite the same kind of porosity.

His work often explores the porosity of borders, both in physical space and online.

Notice how far to the left the porosity goes where all the sand (in yellow) is.

The chalk had very little porosity, and even less permeability.

Determining the true porosity of a gas filled formation has always been a problem in the oil industry.

Recent attempts at obtaining better porosity estimates under these conditions have been reported.

Porosity is a measure of the total pore space in the soil.

The porosity can be tailored using algorithms within the software.

The spheres have tunnels or channels in them of a particular porosity.

This effect is highlighted by the porosity of the façades.

Porosity is the volume fraction of void space in a solid.

I think I will keep on asking the questions and not worry too much about my porosity.

The material produced in this process has a very low porosity of about 3%.