punty , also: pontil

Simultaneously an assistant prepares a 'post' which is another punty with a small platform of clear glass on the end.

However, no pontil (or punty) was used in the process of blowing glass floats.)

Then molten clear glass is 'gathered' over the color by dipping the punty in a furnace containing clear glass.

The hot cylinder of glass is now connected to the post, and gaffer and assistant walk with each punty, stretching the glass into a long rod.

Allowing the pull of gravity to stretch and bend hot glass while on the blowpipe or punty led Littleton to his "Folded Forms" and "Loops" series, which continued until 1979.

Then, the molten glass is attached to a stainless steel or iron rod called a punty for shaping and transferring the hollow piece from the blowpipe to provide an opening and/or to finalize the top.

Streamers are prepared from very hot molten glass, gathered at the end of a punty (pontil) that is rapidly swung back and forth and stretched into long, thin strings that rapidly cool and harden.

The bench is a glassblower's workstation, and has a place for the glassblower to sit, a place for the handheld tools, and two rails that the pipe or punty rides on while the blower works with the piece.

This was then transferred from the blowpipe to a punty and then flattened by reheating and spinning out the bowl-shaped piece of glass (bullion) into a flat disk by centrifugal force, up to 5 or 6 feet (1.5 to 1.8 metres) in diameter.

The major tools used by a glassblower are the blowpipe (or blow tube), punty (or punty rod, pontil, or mandrel), bench, marver, blocks, jacks, paddles, tweezers, paper, and a variety of shears.