ribbon cable

The two cards were connected together with a 16-conductor ribbon cable.

Check the power and ribbon cable to the floppy drive.

Nuts was holding a ribbon cable, grinning up at her.

Strangely enough the thing that most people have problems with when installing a new drive is the ribbon cable.

If you casing is held together by a ribbon cable, take care not to damage it.

If you don't know for sure which type of drive you have check the ribbon cable running into it.

Oh yeah, there's also little stuff, like screws, ribbon cables, and fans which are still pretty important.

The ribbon cable was re- secured, the floor panel replaced.

In most cases the ribbon cable has the three connectors on it that are needed for two drives.

The ribbon cable normally has a red stripe marking line 1.

From a digital point of view, ribbon cable is an ideal way to connect two devices.

To fit the connector locate the appropriate position on the ribbon cable.

The stripe on a ribbon cable traditionally marks pin 1.

The two 3dfx cards were connected by a small ribbon cable inside the PC.

Because of their shape, ribbon cables are ideal for situations where space needs to be conserved.

Removing the case from his laptop, she attached the end of a ribbon cable to the hard drive, leaving the power cables connected.

IDE devices use a ribbon cable to connect to each other.

Note that the last four pins are only used by devices that require power through the ribbon cable.

A formed cover with slots for the blades fits over the ribbon cable and retains the it.

The traditional cable uses 40-pin connectors attached to a ribbon cable.

Both designs incorporated a switch board and a motherboard which were connected by a 12-pin ribbon cable.

The drive connects to the drive controller and other hard drives, if any, through a flat gray ribbon cable.

All the ribbon cables and power leads were bundled up neatly, making for a clean-looking interior.