section steel
sectional steel

Roof bows can be made out of either square section steel, or aluminium.

The frame was made of very stiff section steel.

Homemade galvanised single ski trailer, built from box section steel.

The chassis is a box section steel structure with built-in roll and side impact protection.

The frame was rectangular section steel like the Honda.

Two lengths of square section steel channelling are suspended from the roof about 2m above the floor.

Rack structures are of structural steel or thin section steel construction.

The new pit was constructed by local ringers using sections of bolted flat and channel section steel.

The revised chassis was again made of box section steel and was cruciform braced.

Also in 1969 (June), the plywood chassis was gradually replaced by a square section steel one, which shortened production time and saved on cost.

Manufactured from pre-galvanised box section steel.

Gate frame is of all welded hollow section steel and complete with lockable slip latch as standard.

The frame was Z section steel rails with structural plywood floor, extended by steel tubes in front.

The channel section steel chassis was placed under the axles with suspension by semi-elliptic leaf springs.

The yoke was covered with fibreglass, and therefore visual inspection of the box section steel underneath was not readily possible.

The vertical running frame, commonly made of square section steel, that supports each corner of a variety of vehicle bodies.

Forward of this and beyond a firewall, the inverted in-line engine was mounted on a frame of square section steel members.

Rock sliders are typically made of heavy-duty box section steel, although they can also be made from tubular steel as well.

The chassis is a frame made of rectangular section steel pipes with aluminium bearing panels and fibreglass fairings.

The Perrot-type front brakes are ribbed light section steel and are larger diameter than rear; cast iron shoes.

Larger air handlers will be manufactured from a square section steel framing system with double skinned and insulated infill panels.

Doors are constructed from rectangular hollow section steel and suitably braced for minimum deflection in the open and closed position.

CHASSIS: to be built of tubular or box section steel only.

Wires may be made of multi-stranded cable, a single strand of piano wire, or aerofoil sectioned steel.

The Swallow sports car is constructed on a professionally engineered and built ladder frame chassis using box section steel 100mm X 50mm as its main members.

A full-scale sectional steel model in the exhibition, along with a video, gives visitors the experience of inhabiting a Wexler-designed house.

The stairway is cylindrical, made from sectional steel and structural steel fabric, with 240 oak steps.

The second category of residential furnace is the forced-air, atmospheric burner style with a cast-iron or sectional steel heat exchanger.

It is a single-story sectional steel frame structure, whose exterior is clad in steel with green enamel bands.

The line was electrified with a central rail sectional steel conductor; the sections were connected by copper strips, U shaped to allow expansion of the joints.