set screw

The two pieces are held together with a set screw.

The canopy is held in place with two set screws.

It also excludes set screws, which are covered under part 5.

Once focused, a set screw was tightened to hold the rear section in place.

Set screws appear with a variety of tip (point) types.

A set screw (on those cartridges where it is recommended).

The concept of set screws is many centuries old.

Set screws are made with a variety of drive styles, including the following:

Door stop fastened to collar with 2 x socket set screw.

Blade changing is quick, with an Allen key inserted into a set screw on the inside of the show.

For longer life, set screws are usually made of alloy steel and case hardened.

Insert padlock through provided hole, to prevent access to set screw.

Various sockets types are provided to allow the set screw to be rotated.

The cartridge stop was a rocker design with a set screw on front right side of the receiver.

Set screws can successfully hold against heavy-torque applications if the details are right.

The fittings slip on the pipe and are usually locked down with a set screw.

In orginal box, other than a few set screw marks on the chrome, looks as new.

In most set screw applications, this consideration is irrelevant.

The front sight is pinned in, and the rear held in by a set screw.

Then retighten the set screw and any other screws that were loosened.

Lower pulley to bottom of the elevator and retighten the set screw.

He adjusted the mobile tube for maximum response and tightened a small set screw.

Set screws are not always the best way to resist the torque of driven shafts.