transverse profile

Procedures for measuring both longitudinal and transverse profiles are described.

Thus only in cases where the cavity forces a specific transverse profile are transverse effects trivial.

Transverse profiles show steeper northeast flanks, the lower parts of which are covered with psammophilous grasses.

The transverse pressure angle and transverse profile angle are the pressure angle and the profile angle in a transverse plane.

Series of low gain TEA-CO2 amplifiers are used to study the evolution of beam transverse profile as short duration pulses are propagated through the amplifiers.

Extreme phenomena have been observed in single-shot studies of the temporal dynamics of optical beam filamentation in air and the two-dimensional transverse profiles of beams forming multiple filaments in a nonlinear Xenon cell.

The instrument was similarly used to produce reference measurements by the World Road Association (PIARC) in its 1998 "International Experiment to Harmonise Longitudinal and Transverse Profile Measurement and Reporting Procedures."

In 2011 Barrett e.a. indicated two possible unique traits, autapomorphies: the floor of the neural canal is deeply cut by a groove with a V-shaped transverse profile; the caudal spikes have triangular bases in side view and narrow points.

Instead of the promised 4000 soldiers, the monarchy sent two regiments from Baja with the leadership of their officers to construct barracks, and with the aid of instruments scan the transverse profiles of the foundation pits for locks and channel sections.

In spur gears and straight bevel gears, tooth profiles are considered only in a transverse plane, and the general terms profile angle and pressure angle are customarily used rather than transverse profile angle and transverse pressure angle.

However different modes propagate with a different Gouy phase which is why the net transverse profile due to a superposition of modes evolves in z, whereas the propagation of any single Hermite-Gaussian (or Laguerre-Gaussian) mode retains the same form along a beam.

In helical teeth, the profiles may be considered in different planes, and in specifications it is essential to use terms that indicate the direction of the plane in which the profile angle or the pressure angle lies, such as transverse profile angle, normal pressure angle, axial profile angle.