workpiece

Do not cut a workpiece that is too large to handle.

Up to five teeth can be cut into the workpiece at the same time.

A weight would then be placed on top of the workpiece.

It may be used to hold a workpiece or a tool.

The workpiece would be placed inside one of these rings.

The workpiece is often in the form of a sheet or roll.

Usually they have to be designed individually for a given workpiece.

In the case of some materials only cold air is needed to cool the workpiece.

They have to be in contact with the workpiece to fire a nail.

The light will pass through the glass and reflect off the workpiece.

For example, a workpiece may be required to have a specific outside diameter.

In shaping, the tool is brought into position with the workpiece.

Instead they try, whenever possible, to hold the workpiece in place and mark its length.

It is possible to raise the table (where the workpiece rests).

In all cases, an accessory is used to direct the workpiece.

The tool and the workpiece each carry approximately 10% of the energy.

Moreover, the workpiece is not a part of the electrical circuit.

Less effort is required to apply the drill to the workpiece.

The workpiece would then produce the punch and the die after the cut is complete.

This is useful for the handling of very large, heavy, short workpieces.

Do not release a workpiece until it is past the blade and removed from the saw.

It's purpose is to assemble a bend on a workpiece.

The resulting workpiece may then be used "between centers" in another operation.

It can also be used in a solid workpiece.

The projections can also serve as a means of positioning the workpieces.