anodal
anodic

Electrogustometry is the measurement of taste threshold by passing controlled anodal current through the tongue.

Each device has an anodal electrode and a cathodal electrode.

Compared to sham stimulation, the anodal stimulation led to a significant improvement in fluency.

It is based on the induction of gustatory sensations by means of an anodal electrical direct current.

Reversal of the stimulus polarization provided a mechanism for anodal stimulation of cardiac tissue.

The anodal stimulation is positive (V+) stimulation that increases the neuronal excitability of the area being stimulated.

The anodal electrode is the positively charged electrode and the cathodal electrode is the negatively charged electrode.

When positive stimulation (anodal tDCS) is delivered, the current causes a depolarization of the resting membrane potential, which increases neuronal excitability and allows for more spontaneous cell firing.

During MIT training sessions, the researchers applied anodal transcranial direct current stimulation (tDCS) over the equivalent of Broca's area in the right hemisphere of 6 stroke patients with non-fluent aphasia.

Andrews S, Hoy K, Enticott P, Daskalakis Z, Fitzgerald P. Improving working memory: The effect of combining cognitive activity and anodal transcranial direct current stimulation to the left dorsolateral prefrontal cortex.

IgA has the most anodal mobility and migrates in the region between the beta and gamma zones also causing a beta/gamma fusion in patients with cirrhosis, respiratory infection, skin disease, or rheumatiod arthritis (increased IgA).

By comparing the results in subjects exposed to sham stimulation with the results of subjects exposed to anodal or cathodal stimulation, researchers can see how much of an effect is caused by the current stimulation, rather than by the placebo effect.

The first commercial anodic automotive system began operations in 1963.

Attempts to save a metal from becoming anodic are of two general types.

Anodic etching has been used in industrial processes for over a century.

The ratio of the surface areas between the cathodic and anodic region is significant.

The name comes from the gold colored anodic coating) used on many of its parts.

At the negative electrode, the anodic reaction is shown as:

Anodic regions dissolve and destroy the structural integrity of the metal.

The anodic current is the flow of electrons into the anode from a species in solution.

Corrosion will occur at the area of low-oxygen concentration which are anodic.

It may be prepared by the anodic oxidation of calcium bromide.

The procedural steps of anodic bonding are divided into the following:

The anodic process avoids this effect since oxygen is being generated at the anode.

This causes the passivation of steel at the anodic oxidation sites.

The plant for anodic material will be established in 2010 and commercial production will start in 2011.

The cathodic current is balanced by the anodic current.

Electric current will flow from the anodic areas into the electrolyte as the metal corrodes.

Anodic corrosion during the reaction can disintegrate the aluminium.

In some cases, the amines form a protective film on the steel surface and, at the same time, act as an anodic inhibitor.

A critical anodic potential seems to exist at which a maximum power output of a microbial fuel cell is achieved.

Fuel cells rely on catalysts for both the anodic and cathodic reactions.

Differing coefficients of thermal expansion pose challenges for anodic bonding.

The pits become loaded with positive metal ions through anodic dissociation.

The cathodic process results in considerably more gas being trapped within the film than the anodic process.

Since the anodic reaction occurs very quickly, the charge transfer limitations are thought to occur at the cathode.

The theoretical values of a and b are different for the cathodic and anodic processes.